PDA

View Full Version : Breakaway bottles


Riff
04-17-2007, 02:33 PM
I've started making bottles, but I need a good dye for beer bottle brown. Any thoughts?

Roderick Usher
04-17-2007, 03:57 PM
Dark Kayro (called "golden syrup" in this recipe I found)

Instructions

Materials :

* Old saucepan
* Oven
* Baking thermometer
* 2 measures of water
* 1 measure of golden syrup
* 3 1/2 measures of sugar
* A mold for your glass (depending on the shape requirements)

Steps :

* Mix the water, golden syrup and sugar together in the saucepan and bring it to a boil on the oven.
* Leave it boiling until the mixture is thick, with almost all the water boiled off.
* Pour it into whatever mold you're using and let it cool.

Notes :

* Keep it out of moist areas and direct sun.
* Sugar glass doesn't last long (warps or goes sticky) so make it close to the time when you plan to use it.
* Though only sugar, the glass can have sharp edges/points when broken, so be careful when handling.
* Do not let the sugar caramelise otherwise it turns into a horrible brown
* To achieve the see through glass affect use liquid glucose instead of golden syrup. It still has the same properties just that it is clear.

Riff
04-17-2007, 04:03 PM
Thanks, but I'm doing Pico resin, not sugar glass. It holds up better under the hot lights. I should have specified.

Roderick Usher
04-17-2007, 04:39 PM
this site says to use Translucent Resin Dye

http://www.fxsupply.com/materials/break.html

Riff
04-17-2007, 05:03 PM
Yep, but they don't have a brown translucent. The guy who works there said I could just spray paint them, but I'm worried about the paint interfering with the breakage.

chaibill
04-17-2007, 06:29 PM
red yellow and blue in equal parts makes brown try food coloring
are you making a movie or just playing around?

Roderick Usher
04-17-2007, 07:34 PM
hmmmmm:confused:

Well I'd just add come stain to the resin before it sets. But if you already have the bottles made, how about you dye decoupage's glue and paint a thin layer over the bottle?

bwind22
04-17-2007, 09:07 PM
Well I'd just add come stain



hahahahaa.

Roderick Usher
04-17-2007, 10:45 PM
um, yeah...that was a typo:o

Riff
04-18-2007, 05:02 PM
hmmmmm:confused:

Well I'd just add come stain to the resin before it sets. But if you already have the bottles made, how about you dye decoupage's glue and paint a thin layer over the bottle?

That sounds like a solid plan for the already made ones. Bill, that works in theory, but in practice usually it's not equal parts. It depends on the tinting strength of the dyes. I didn't know if anyone on here had worked with resin dyes before and knew the exact ratios.